Materials
Fiberlogy Easy PETG
Easy-printing PETG from Poland, sold on 0.85 kg spools and priced in euros.
Verified November 2026 · Fiberlogy data, linked belowPrint settings
- Nozzle temperature
- 220–250°C
- Bed temperature
- 90°C
- Density
- 1.29 g/cm³
- Length per kg (1.75 mm)
- ≈ 322 m
- Enclosure
- Not needed
- Drying
- 60°C for 4 h
About PETG
Tougher and more heat resistant than PLA, food-contact grades exist, strings more. Bonds strongly to smooth PEI.
Getting good results with Fiberlogy Easy PETG
- Start near the middle of the range (235°C) and print a temperature tower to find your printer's sweet spot.
- Faster printing needs a hotter nozzle; slow, detailed prints look best near the low end of the range.
- No enclosure needed; keep part cooling on after the first few layers.
- Dry it (60°C for 4 h) if you hear popping, see extra stringing, or the surface turns rough.
Plan a print with the print cost calculator or convert meters to grams with the filament converter. Always check the label on your spool, since makers update their recommendations.
Sources
The temperatures, density and drying setting were checked against the maker's own published data in November 2026; the notes and tips are our own summary. Values we could not find in the maker's data are marked as such.
Common PETG print problems
Fix guides for the problems PETG runs into most often.